Questions & Answers for: Saturn belt tension

...belt goes OVER and holds tension. Take a wrench (the proper sized one of course) and turn it to the left. It will be tough because it is under spring load (tension), once you remove the tension by ...

how replace serpentine belt on 2000 saturn l I fully realize this is the same question you re-asked later on. I want to make sure you receive an answer either way. Click on the following direct Link. ...

how to replace serpentine belt on 2000 saturn L series not ion Click on the following direct Link. It has the Serpentine Belt Diagram for the L-Series for your specific engine and options (AC/No AC ...

how to remove and replace a serpentine belt 96 saturn how to remove and replace a serpentine belt on a 96 saturn Click on the following free, direct Link. It has all the Serpentine Belt Diagrams you ...

Belt Tension The belt is automatically adjusted using a spring loaded tensioner. If belt slippage is suspected or unusual belt noises occurs, the following procedure should be used to determine if the

or 13 mm wrench on the center bolt of the tensioner pulley to release the tension. Remove the belt. There will be two bolts that hold the tensioner to the motor. A 10mm socket will work to remove them

...tension on the belt. Take the belt off the upper-right hand pulley only (unless you're replacing the belt as well) toward the front of the car. Allow the tension to go back and remove the wrench. 4 ...

...tension on the belt by rotating the tensioner until tension is released on the belt. properly. Some tensioners don't have a square hole to put a breaker bar, but must be turned at the pulley's ...

...belt tension by moving the tensioner arm. if the serpentine belt is still on the lower pulley then put the belt on everything except the tensioner, then move the tensioner arm as needed, put the belt ...

...tension on the belt. Remove the belt and CAREFULLY release the tensioner. Route the new belt over the pulleys, again rotating the tensioner to allow the belt to be installed, then release the belt ...