Question about 1987 Delta 88
...belt. One sensor is the crankshaft position sensor and the other is... I forget... crankshaft angle sensor or something. I replaced both on my car. I don't know wich one is your problem. When you buy ...
Car wont start. Changed coil and module, battery is good.Car is turning over but seems to be not getting electric to module. Check the ignition switch, or timing belt. or crank position sensor.
...belt, remove the harmonic balancer with a special puller designed for that type of engine, then finally, remove two little bolts holding on the sensor and replace it with a new one...........it all ...
belt or timing chain to make sure it is not broken or slipping. If you are not getting spark, you will need to check the spark plugs, coils, coil packs, wires, distributor, distributor cap, and rotor.
...sensor's. Belt driven fan, belt slipping, fan clutch is bad, fan blades have flattened out. Air dam under front bumper is gone, loose, or broken. It actually has a purpose other than scraping on ...
...sensor which has 3 wires going to it and is mounted behind the belt near the waterpump. the magnet will sometimes break off its holder and that will keep the engine from starting as it can not ...
Question about 1987 Delta 88
...sensor in the belt buckle that wears out over time and also gets dirty. Try cleaning the buckle if that does not work replace the sensor. Does the drivers window not roll down and that is what makes ...
Usually answered in minutes!
205 Questions
164 Questions
91 Questions
87 Questions
87 Questions