Questions & Answers for: Ford Mustang belt sensor

Sensor I have a consistent sound when I start and drive my Ford Mustang 2003 convertible. I had the belt replaced, but it didn't fix the problem. I was told at a dealership that the cause of the sound

Seat belt tone dings when belt is buckled Damn Fords :-) the seat belt is freakin is buckled but it constantaly dings as if it weren't buckled drivin me freakin crazy man. I've checked the relays but ...

...sensor, ball joints, struts, fuel pump, fuel filter, new belt, with in the last 5 month. Some say it may be the compressor and some say it may be an electrial problem like another sensor going bad ...

...belt and set the timing. BUT NOW I have no spark. any ideas.. Check your crank sensor. Sometimes, it can be put back in backwards causing no signal from the crank, therefore no spark. Check to see if ...

...belt alarm stays on most the time but when i go over a speed bump some times it goes off and starts malfunctioning again when i go over another bump. i know it is the relay but i don't know were to ...

...sensor Timing belt/chain tensioner damaged First, visually inspect the cam and crank sensors and their harnesses for damage. If you notice broken/frayed wires, repair and recheck. If you have access ...

belt sensor, occupant weight senor for air bags, heated seats & power seats (could be more than one wiring harness. Look inside belt buckle fastener; is it crusty with anything (food, crumbs, coin

belt changed. Do you know if the compressor stops working when you are getting hot air ?  The computer will turn off the compressor when you are at wide open throttle.  Could be the throttle

...sensor About a week ago, my car would stall (not all the time) when at a red light and sometimes while driving it acts as if it wants to shut off (never has though). Also, when it is acting up, there ...

...belt tighten around their pulleys, check for a little deflection, 1/2" maximum and tighten everything up, if you still hear chirp or squeal pry out a little more till the noise go. vic Cam position ...