Questions & Answers for: OKI belt sensor

...were placed into the machine together and the blue handle is locked. the sensor error happen to me because i replaced the belt and i didn't lock the buttons correctly that solved my sensor

belt sensor should be replaced? Where is the belt sensor - i see only a thermistor listed on the C5100N drawings for repair and service. Thank you for you help! Greg Greg, The classic machine gun type

...belt **** sensor. Usually it means the printer can't see the transfer belt rotating. First thing to try is to remove and re install the transfer belt, if that does not work you should replace the ...

belt many times and never received this error in the past. Any help would be greatly appreciated. Thank you in advance. Magenta toner sensor error. Reseat drum unit. check toner cart. Take out the key

belt unit, m32 board, power supply board, high voltave board, fuser etc,. but the problem is still there.. please help me.. your help will be very much appreciated thanks guys More power... Your error

...SENSOR ERROR Cause: This generally can be caused by two things. 1. The toner cartridge lock lever is not in the correct position. 2. The Transfer Belt lock levers are not in the correct position. ...

...belt **** sensor error. Power off/on917:Fatal Error This is the message I'm getting on my Oki 9650 printer. I've turned everything off, unpluged, then started again. Aany ideas as to what might be ...

...sensor should have raised an alarm), you could try extracting the belt unit and re-settling it. Verify the blue retainers have been fully rotated (one eighth turn clockwise) and the handle is ...

belt. on the right side is the reg rollers. there is a black arm and sensor the detects the paper weight etc there. that will control the paper sense errors, make sure it moves freeley, clear of paper

...and is now confused. Help! Open the machine and remove the paper tray, the drum tray, the transfer belt and the fuser. Check all for a sheet or part sheet of paper. replace all and retry.If still ...