...belt is not moving, or the sensor that monitors the belts movement is bad,or the belt has torn and is physically unable to be monitored, or (save the best for last) the main controller has lost its ...
...belt (there is a detection mark on it that needs to be read by a sensor) or the main motor. Since this is such an old copier, it may be hard to find replacement parts for it, however. Hope that
color registration error put out image transfer belt and chek the belt and the registration sensors(music)this problem can happened if the density of c-m-y colours are low!!
Question about DSm645 Digital Imaging System
gestetner dsm645 error code sc548 solutions of free SC548 is fuser belt rotation error, check the 2 sensors on the left hand side of the copier (as you look at where the fuser is located). These get ...
...board or the SBU . Check the wires between scanner motor and the scanner I/O board Fix the scanner motor. Fix the Home Position sensor. Fix pulley, timing belt, the scanner wire, Fix the
belt sensor does not detect change in the actuator for 0.5 seconds after the fusing/paper exit motor has turned on. * Defective fusing/paper exit motor * Deformed actuator for the fusing belt sensor *
Question about DSm645 Digital Imaging System
...the color registration adjustment fails on a Gestetner C2500 The ID sensors are dirty or transfer belt unit is damaged/dirty/faulty. The ID sensors are below the fusing unit facing down onto the ...
Usually answered in minutes!
33 Questions
21 Questions
25 Questions
22 Questions