...like this! Check the crank case position sensor, this is a magnetic sensor that bolts into the bell housing on the back side on top of where the transmission connects. If you check your codes
...after a run? Other ideas? THANKS yes it has a crank sensor below the dist in the top of the trans bell ...
...at this point. Any suggestions? it is a loose ground to the starter. look for a ground to the bell housing. chances are it's loose this is the ground for the solenoid on the starter. I had the ...
...stop ringing Even though the car is running & door is closed the ignition bell does not stop ringing. How can this be stopped? It was the seatbelt chime - our solution remove the module. Thanks ...
How do I disable the seatbelt chime on an '89 VW? How do I disable the seatbelt chime on an '89 VW Cabriolet? It's driving me nuts!!! look at the buckle and see if there are two wires going into it. ...
...not getting spark ,ive replaced the coil and still no spark Behind the engine on top of the tranny bell housing is the crank angle sensor. Try wiggiling the harness. Check the Ignition Circuit ...
where is my starter located on a 1992 volvo 240 gl the starter will be bolted on to the gearbox bell housing thats were the gearbox bolts to the engine
95 volvo 940 dies at different speeds but will start right back up, where is the cranksensor located so i can check it on top of the bell housing of the tranmission it have one bolt a 10 mm
Question about 1995 940
...plug in part the Crankshaft Position Sensor is located between the firewall and the engine on the bell housing which connects the engine to the driveshaft Right on the top shine a light down in ...
Usually answered in minutes!
299 Questions
116 Questions
117 Questions
111 Questions