...go for the assembly of the new starter. Look at the rear of the starter where it attaches to the bell housing. Here you will see some large bolts attaching the starter flange to the bell hosing. ...
4x4 will not engage but light comes on Check the front bell housing for signs of fluid leak. Check for any disconnected wiring or block linkage movement Check the oil level inspection plug for the oil
Question about 2000 Sportage
Where is the crankshaft sensor located on the 2000 Kia Sportage? The ckps is in the bell housing of the transmission so it can read the flywheel. Should be right on the side held in by 1 bolt and ...
location of crankshaft position sensor on 1999 kia sportage The crankshaft sensor is in the bell housing,near the flywheel.If this was helpful,please rate,thank you
The seat belt chime goes off constantly even tho Im belted in..I took out the fuse for it and it stopped but I had no signal lights then. Its a 2000 Kia Sportage..please help me solve this I think Im ...
Question about 2000 Sportage
gauges work but no lights on dash board and radio does not work cig lighter works, rear defrost work, headlights work, dome light works, door chime works, shift position lights work, windshield wipers
kia sportage wont start usually a bell sounds when the key is put into ignition. Occasionally it will start then stop however still does not crank as is completely dead. Battery is good and all fuses ...
Is there any way to stop the bell chiming noises sounding all the time with the doors open? Its a 1998 kia sportage. Remove the chime
does manual gearbox of 1997 kia rio fit 1997 kia sportage Look to see if they are the same part number first. Then see if the bell housing is the same.
Question about 1999 Sportage
...It's a manual transmission. Hi There is a bleed nipple at the slave cylinder attached to the bell housing . There is a bolt on the side of gearbox about the middle take this bolt out and ...
Usually answered in minutes!
1,074 Questions
1,058 Questions
918 Questions
753 Questions
343 Questions