Question about KP26M1X Stand Mixer
...beater is banging on the side of the bowl. I have adjusted the screw on the mixed behind the bowl to no avail. It doesn't seem to matter which way I turn it - and it doesn't turn very far either way- ...
...and Care Guide about the beater to bowl adjustment. This is an easy adjustment made with a flat head screwdriver that can quickly correct the problem of a flat beater hitting the bottom of the
bowl flies off of base- beaters are hitting the sides of the bowl There should be a turntable offset to avoid contact ofbeaters and bowl. chk the base for a slide lever.
...hitting the bowl before I had the bowl in the locked position. I got the top of the gear box off but can't see how to get the planetary gear off. Hi TJEWKES67. Before you tear into the ?guts? of your ...
Question about KT2651X Epicurean Stand Mixer
side of the bowl. If the flat beater or the wire whip is so close that it strikes the bottom of the bowl, coating may wear off the beater or wires on whip may wear. Good luck and have fun. I hope this
Question about KP2671 Professional 6 Series Stand Mixer
...side) unless it got dropped...eek! Sounds like a head height adjustment issue. Check out this from KitchenAid Conversations: http://forum.kitchenaid.com/forums/topic.asp?TOPIC_ID=3032 Good luck. DZII ...
...Turn it ccw a turn and check the beater to see if it is still hitting the bottom of the bowl. Repeat the procedure until you have 1/4 inch clearance or so from the bottom of the beater to the
...beater hits bottom of bowl I've tried to tighten screws with no results Try adjusting the height of the head by turning screw #36 counterclockwise a turn or so. This will raise the mixing head so the ...
hitting, and scuffing the side of my beater. I'm worried it's going to chip off the coating, not to mention damage my mixer and bowl... any suggestions?? What part number did you order for the
Question about KSM150PS Artisan Series Stand Mixer
...beater hits bottom of bowl beaters vibrate and hit side of bowl Your worm gear is no longer seated and that is more than likely because the housing cover is probably the old style plastic and it has ...
Usually answered in minutes!
493 Questions
357 Questions
324 Questions
285 Questions
205 Questions