...2 167nm Big ends Stage 1 29nm Big ends Stage 2 45 - 60 degrees Hope this helps 2.3 ENGINE MAIN BEARINGS TORQUE IS 72 FT LBS ROD BEARINGS IS 43 FT LBS. THE 2.6 ENGINE MAIN BEARING TORQUE IS 72 FT ...
why are my wheel bearings failing again why are my wheel bearings failing ? again replaced under 1 year ago and 30000kms ago I would say that a premature bearing failure would be caused by a defective
...go bad or is their another bearing behind the drum that the drum needs to be removed? if the bearings are rusted or seized u need to change main seal near bearings. was it noisy b4 you looked ...
2wd front wheel need to replace bearings or hub assembly which is best A Front Wheel Drive Vehicle Can Have Two Types Of Rear Wheel Bearings: Serviceable Bearings, Or Nonserviceable, Sealed Bearings. ...
need to change front wheel bearing Hub and Bearing Removal & Installation NOTE: The removal and installation of the wheel bearing and hub from the steering knuckle is only to be done with the ...
...You can also contact Timkin Bearings about the bearing at: http://www.timken.com/en-us/Pages/Home.aspx Please take time to rate ...
how long do bears hibernate for Response from Sean Farley, Research Biologist and Bear Specialist, ADF&G Question from A. Chapman, Anchorage Q) Do bears really sleep all winter? Do they need snow ...
Question about 2004 PT Cruiser
...or the housing that holds the cranks, in other words. I would remove the crank and inspect the bearings. There are several different types of bearings. If your bike uses sealed bearings, your ...
Question about 2004 Ozark 250
...on them somewhere. If you have your old bearing, you can match the numbers. You can measure (BOTH BEARINGS) the bearing I.D., OD., and width with a GOOD set of calipers!! I have seen, rarely, ...
Usually answered in minutes!
191 Questions
163 Questions
151 Questions
96 Questions