...Body Control module? or one of the door ajar sensors? Get a wiring diagram. Unplug connector from BCM and do a continuity check on each door at the BCM. That'll tell you whether it's a door switch, ...
...steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the bcm. Remove the bolts holding the junction block to dash panel mounting bracket. Remove the
Question about 1999 Town & Country
...steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the BCM. Remove the bolts holding the junction block to dash panel mounting bracket. Remove the
Dealer says $200 for new BCM with trade of ''core''?? BCM has been diagnosed as ''bad.'' Dealer says will replace BCM for about $200 if we let them have the ''core.'' What are they talking about? ...
Question about 2002 PT Cruiser
Where is BCM located on 2002 PT Cruiser locks working even when car is not on have been told to check BCM don't know where to find it Where is BCM located on 2002 PT Cruiser locks working even ...
Question about 2005 Pacifica
...Hi Anonymous, Im glad to help! The U110C is a BUS Message and usually has to do with both PCM and BCM, because its a lose of BUS Signal between the PCM and the BCM. FIRST THING TO TRY: The first ...
Headlights won't turn off Your headlamps are controlled by two different modules , BCM -body control module an integrated power module ! Your headlamp switch is a low voltage input to the BCM , after ...
Question about 2003 Town & Country
...change your meter to vdc to see if power is coming to the wire. If not, trace the wire back to the bcm to see if the wire is cut. If not, remove the connector from the bcm to see if the terminal is ...
Question about 2008 Town and Country
...With Body Control Module "A" https://www.obd-codes.com > u0141 Code U0141 pertains to the BCM "A" or the wiring to the BCM from the engine control module (ECM). The code, depending on the ...
Question about 2008 Town and Country
...do you own a voltmeter (DMM) and scan tool? On this car the PCM controls and ATCH if there. AND BCM all fuses good, skip one, remove battery log minus (-) for 1 hour and put it back (resets) OBD2
Usually answered in minutes!
1,229 Questions
1,289 Questions
1,198 Questions
1,079 Questions
1,173 Questions