Question about MicroTalk PR 1100 WX (15 Channels) 2-Way Radio
...center and ask the tech to jump the battery. if the battery falls below a certain voltage it might need a quick jump sart from a power supply with a higher voltage normally 12 volts works
battery area,use the edge of a thin blade knife to probe that area for any movement. However before this are you sure that the charger is working? and/or putting out the requried voltage, this voltage
...battery charger . When we installed them we have the same problem. the cobras are meant to work with alkaline cells. You bought nicads which are a lower voltage per cell (1.2 to 1.38). Alkalines are ...
Question about Microtalk 100 FRS Walkie Talkie Radios 2 Pack
battery,checked with vom it is 5.96v. I switched to the PA function on the radio there is good modulation with no distortion. Also the radio receives with no problem Any thoughts as to what is causing
...voltage could caused by low battery. Poor connetions. Wire too small for load being supplied.Inverters over 1500 watts will require #1/0 or larger cable, in the shortest possible length. NOTE: Cable ...
Question about Ga-cs Or Ga-cl Microtalk Charging Stand Charger For Priss Walkie Talkie
What volt charger is needed for (cobra microtalk pr560wx)? Thanks,Richard Hi Richard, Volt Charger??? I'm not sure what you mean, but if you mean what voltage to recharge the batteries, then you need ...
...battery voltage is ok with the battery pack information.every battery pack have text telling you the voltage and Amps. For example if the battery voltage is too low the handheld do not receive. Check ...
what size supply fuse I = P/E Current = power/voltage Therefore 25 watts of power divided by 12 volts if that is the battery voltage, equals about 2 amps. You should try a 3 or 4 amp fuse..
Question about MicroTalk CXT145 Walkie Talkie 16-Mile Radio
MY COBRA MICRO TALK BATTERIES WILL NOT CHARGE HOW DO I KNOW IF THEY ARE CHARGED? if you have a volt ohm meter see if theres voltage at the power adapter plug or the battery itself
Question about FA-CG Micro Talk Walkie Talkies
...battery contacts. You need a higher voltage than 3.6 volts, but milliamps is more important. You need enough milli amps to get the radio to transmit. Too much and it frys, literally. So, this is all ...
Usually answered in minutes!
980 Questions
274 Questions
141 Questions
137 Questions
112 Questions