Questions & Answers for: Cadillac battery voltage

Question about 1994 DeVille

1 Answer

...battery voltage too low--at 800 rpm, voltage is less than 10.6 volts I052-keep alive memory error--means IPC lost voltage, and reset. Normal if battery was disconnected, or lost voltage. These codes ...

Ad

Question about 1991 Seville

1 Answer

...battery. If the voltage is above the rated voltage by a couple of volts then I guess the alternator is not the problem. Keep the voltage tester connected to the battery and stop the car. If the ...

Ad

...YOUR BATTERY VOLTAGE IS LOW. a full battery has an anbiant voltage of 12.6 v..9.5v will not start your car.the voltage during cranking needs to be above 10.5 or it will not start.get a new

...lator output voltage, and get the right voltage. Get this done,. and send your e-mail for the result. Your battery is likely reaching the end of its usefull life. The solution is to replace the ...

Question about 1997 Seville

1 Answer

...battery voltage should be between 12.5 and 12.8 volts.(You will need to use a voltmeter for this testing procedure) The alternator is rotated by a drive belt driven by the vehicles engine while it is ...

...voltage reading at the battery should be 14.5 volts, but a reading between 14 and 16 volts is acceptable. If the voltage reading at the battery is less than 14 volts when the engine is running then ...

...battery voltage on the first test then you will have to check voltage at the starter. the large wire should have battery voltage without starting and the small wire should have battery voltage only ...

Question about 1999 Seville

1 Answer

battery voltage, now switch to high beam and test for battery voltage if ok remove the grounded meter probe and probe the cable in the socket that you have not tested this is the ground cable, battery

...battery voltage to stop lamp relay control circuit and the center high mounted stop lamp (CHMSL). When the stop lamp relay receives battery voltage from the BCM, the relay coil is energized and the ...

Battery Voltage parameter in the DIM data list. Does the scan tool indicate the battery voltage is greater than the specified value? 9.5 V Measure the voltage across the battery terminals. Compare the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cadillac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...