Questions & Answers for: Mercury battery status

...battery terminal of the starter relay. Remove the connector from the "I" terminal of the starter relay and insert the male pin of the overlay harness into the connector. Install the female connector ...

...battery was dead. I found out that my son tried to boast the car. I'm assuming he did someting wrong because the 100amp fuse was blown and I had to replace the alternator. Now the fun starts. I took ...

...battery consumption. During the sleep mode, the GEM turns off all outputs and monitors the following: Door ajar (Both front and rear doors, and liftgate). Key in ignition. Key in RUN or ACC. Door ...

...battery cable. Confirm operational status of the air bag system by turning the ignition key to the RUN position and visually monitoring the air bag indicator lamp in the instrument cluster. The ...

status. What component(s) could possibly cause this? Thanks. your battery isnt what was bad to begin with, if it is discharging either change, or have your alternator rebuilt.. thats your problem 100%

...battery 10 minutes, then reconnect it, and start the car up and let it idle 10-15 minutes. If no Check Engine light is on, take it for a drive. Around town, and on the highway. This will get the ...

...battery damage caused by over and under charging. Using this algorithm, the PCM determines the optimal voltage setpoint for the charging system and communicates this information to the voltage ...