Questions & Answers for: Jeep Wrangler battery fuse

Ad

...fuse.If the battery is dead, it will start with a jump start, but it will die shortly after you remove the jumper cables for the same reason.This is one of those problems that you might not think of ...

Ad

Question about 1990 Wrangler

1 Answer

...Positive battery cable to the fuse box. tighten the nut that connects the battery cable to the fuse box. if this car has a security system, and the battery went dead. you may need to reset the

Ad

Question about 1997 Wrangler

1 Answer

...FUSE/RELAY BOX NEAR THE BATTERY. PULLOUT THE FUSES, LARGE & SMALL ONE AT A TIME, IF THE LIGHT STAYS ON PUT THE FUSE BACK IN TRY THE NEXT FUSE. WHEN THE LIGHT GOES OUT, THAT IS THE CIRCUIT CAUSING ...

Question about 1997 Wrangler

1 Answer

...fuse, altenator and battery have been tested good, these fuses are in the box under the hood. dont have any idea what to do next HELP a fuseable link is inches away from the alternator's battery wire ...

...hood next to the battery, there is an "engine" fuse. Controls power from the battery to the computer and engine electrical systems. A battery short would very possibly blow this maxi fuse (30

Question about 1992 Wrangler

1 Answer

...BATTERY CABLES VERY OLD YOU COULD HAVE BAD GROUND BATTERY CABLE.IF BATTERY CABLES GOOD.CHECK HEADLIGHT FUSE SHOULD BE 25 AMP FUSE.IF FUSE OKAY.YOU HAVE FAULTY HEADLIGHT SWITCH OR FAULTY DIMMER

...Fuse Block" fuse blows out. If the battery is charged the fuse works fine. Sounds like you need a new battery, before you can continue with any testing, if the issue is still there with a new ...

...fuse box. any suggestions? battery is dead. check fuses, the clicking is the starter relay that is its job is to click. but if it rattles that means low battery what we do is a AAA jumper of battery, ...

Question about 2000 Wrangler

1 Answer

...fuse blows with any short, ending possible fire. sounds like you have gross electical issues. even bad battery terminals. clean them. try a fresh charged battery use a voltmeter and measure voltage ...

fuse, if the battery is new, and charged.? 12.6v dc rested.?
if the battery was installed backwards, oops....a....daisy....boom.

im sure something has power, but if wrong
then you blew up

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...