Questions & Answers for: Harley Davidson FXD Dyna Super Glide battery cover

How do I remove the battery from 2003 Harley fxd Remove the seat. Look on the left side of the battery box. There are two bolts there connecting the battery tray to the frame, loosen these two bolts. ...

...battery and starter. Look under the "electrical panel cover" just to the rear of the coil cover and find the starter relay. Turn the ignition switch on and press the start button while holding this ...

...battery cover on the right side of the bike and there are two bolts between the battery and the rear wheel on the frame. Loosen these two bolts. Now, look down into the frame from the top and just ...

...from the battery and you'll see a jack bolt. Turn the bolt counterclockwise and the battery tray lowers and you can remove the top cover and surround. Then you can get to the cables. Good luck ...

...battery cover with the one Phillips screw below the cover, remove the hold down strap, undo the negative cable connector first and then the positive one and then remove/pull out the battery. Reverse ...

...battery cover can be angled downward and removed allowing access to the battery and tray. always remove the negative cable first and when reinstalling, the negative cable should be the last one to ...

how do get the battery cover off 2010 dyna super glide custom Phillips screw under bottom of cover on righht side.

battery cover, disconnect negative cable and ring terminals. disconnect positive cable and ring terminals, remove rubber strap, remove battery. If you have securiy siren remove battery cable within 30

battery cover remove battery cover removal Remove seat. Disconnect battery. Undo two bolts at rear of battery box. Push down on Left side of box(rear of box). Slide out top plate. Pull box out and up.

...first and/or have it recharged and tested. Take the battery cover off of the right side under the seat and the battery posts will be there. DO NOT connect backwards. Always connect negative