Questions & Answers for: Pride Mobility Products battery charger

wont charge I'm getting 30 volts out of my charger but the charger shuts off when I hook it to my scooter. I can charge the batteries with my car charger. The lights on the charger go from yellow to ...

...battery charger to each battery for 30mins. this was enough to raise the voltage for the normal charger to work If it is only 11 months old, I suggest that you get hold of the nearest Pride service ...

battery leads, the charger thinks the batteries are charged as the voltage coming out of the charger rises to the high level. Some chargers will cut out if this happens. It is probably not the charger

battery connectors, or wiring from the charger socket to the batteries. Try moving the charger plug in the socket while the charger is operating. These sockets sometimes wear and dont contact properly

...battery charger cable called (Sealed Lead-Acid Charger) to replace an older (Lead Acid battery charger). The New Battery charger will charge for about 2 to 5 minutes and then stop charging. The old ...

...charger powers on, but will not run the charge to the battery unit. I have presed the reset button on the battery (pack), removed and reinserted the fuses on both the battery pack and engine ...

...you unplug the charger you will be reading the battery voltage. After charging overnite you should be reading 26-30 volts dc if you aren't getting that voltage replace the batteries Hope this ...

...charger but batteries will not charge If your battery is totally flat some chargers see this as connecting to a short and will not charge. If the battery has a charge run it down some, my batteries ...

charger , can you check the battery voltage anywhere from 26 volts DC to 28.3 volts DC no more otherwise you shorten the life of the battery. You really want the voltage level to be near 28 volts that

...battery charger 13 volt reading per battery unsure on board battery what volt readings per battery how do i know on board battery charger is charging Should use proper 24 volt 2-4 amp off-board ...