...alternators mitsubishi shogun 1994 2.5td gls fitted 2nd hand alt lasted two weeks before flat battery.fitted brand new alt lasted two weeks.turn on ignition start engine 14volts at batt for ...
78 T Bird Not Charging. Have replaced alternator. Battery was charged off car. did you inspect the + and - batt cables for damage? trace both cables esp the - to where it bolts to a ground. is your ...
Question about Harley-Davidson Motorcycle Desktop Telephone
...starter hook a voltmeter to your batt and hit the starter button if it drops to2or3 volts then comes back up when button is released you need a starter it should only drop to about 6 volts under ...
Charging voltage is 27.5vdc, batt voltage 27vdc after charging. Green batt indication starts out all green then drops to two green leds lit. Is that normal? Normal for a battery that is starting to ...
Battery will not stay charged. Changed alternator and battery already. battery cable corrosion-voltage drop test across cable from alt to batt and batt gound to engine---if over 0.3v replace cables
new batt. new alt, 97tercel. batt still runs down after a day or so. alternator puts out til headlights are turned on ,then the out put voltage slowly drops below 12volts. REPLACE BATTERY CABLES THE ...
G'Day.. I have a Plega Traveller, (it no longer G'Day.. I have a Plega Traveller, (it no longer uses internal charger) When batts fully charged indicates they are not and acts as if they are not. (ie.
Question about 1997 Tercel
...please help? I use to have 2 car amplifiers sundown audio saz3k and with a stock alt and 3 back up batts and my voltage would stay at 14.8 and never move. I upgraded to a new amp 7k and that's where ...
Question about 1996 Explorer
96 ford explorer battery light on volt guage high then lights blink and drops to normal and batt light goes off for a few seconds then it does it again but it does not die. Whats wrong? 96 ford ...
ford ranger drains battery How To Perform Parasitic Draw Test EricTheCarGuy take a multi meter switch on amps now loosen your neg batt terminal place your leads between the batt and the loose terminal
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions