Questions & Answers for: ballest

...dlp Hi, My tv has no picture, three lights blinking. replaced bulb and ballast. have 380v to ballest and 5v to small blue wire on ballest. any ideas? change main board, theres no solution

Ty-la1000 has been replaced, but won't light? could it be ballest board. I have replaced the lamp on my PT-50LC13. When I try to turn on tv I get a steady flashing green light, then a red light and ...

...cover towards the roof and you have removed the trim cover. Now all you have to do is change the ballest for the tail light to work . Remove the 2 screws one on each side. Unpluge the ballest in ...

...at the High Tension or coil wire outlet. Any suggestions couple of things does the mustang have a ballest resisor fitted between the ign switch and the coil? in which case it should be a 9v coil or ...

Microwave seems to hum after you shut door. the ballest is going bad

have 1983 dodge truck replaced motor truck started and ran orange wire on drivers fender burned into now truck starts but dies in 5 seconds or less any ideas? Ballest resistor is bad

..... This unit has cooling fans and it sounds like they are either plugged or not working. When a ballest usually goes out it does not come on and then go out. It is the coming on part that is hard ...

The lamp light comes on and no picture. Replaced the projection lamp, but still have problem. could it be the ballest for the lamp? yes

...volts ac or the 3000 volts ac that means crash,burn and fry. so de-energize first. The replacement ballest must be rated for the wattage of the flouresent bulbs ,the length of the flouresent bulbs ...

installed a mitsubishi 62530 lamp and the orange light is still on DO YOU HEAR THE BALLEST POWER UP AT ALL IT MAYBE BAD OR DI YOU PUT THE DOOR BACK ON THE LAMP ?