...shop an now tell me that the lamp failed again an there was another part out an they did not recommend repair. I asked for a refund of the lamp since the all the web companys list 180 day replacement ...
...ballast can usually cause a lamp to loose about 60 % of its brightness levels. The other possibility could be the DLP mirrors need polishing but that is something better left to a repair shop as the ...
Question about 42H81 42" Rear Projection Television
...is usually not all that expensive a part. The repair cost from a service shop can be about $300 or more. If you are handy, you can replace it yourself. Check out www.thepartstore.com for the
...Ballast listed for this tv so the Lamp code is important when ordering from online merchants or you have a trained Samsung tech take care of this for you. 1-800-Samsung can give information on the ...
Question about XL-2100U Projector Lamp for KF-42WE610, KF-50WE610, KF-60WE610, KDF-60XBR950, KDF-70XBR95
ballast could've been damaged by the defective supply. Also, try a known-good lamp...just to rule out a defective new one--in the shop, we kept all old working lamps as testers. just replaced lamp and
Question about WD-65733 65" HDTV
...when the lamp is lit. Sounds like the lamp ballast isn't ramping up the voltage the way it should. May have to replace it. A good service shop would be able to do this for you. Blessings, A/V Media ...
...shop; the lamp and ballast need replacing. My tv model # is HL-T5075S. where is ballast location? FOX has Lamp for $109.00 1-800-227-5369 Encompass Parts has Ballast $54.43 1-800-638-3328 Encompass ...
...ballast, about the only thing left would be the light tunnel which is part of the light engine(optical block) which is very expensive to replace. Was it like this before the old lamp went out? the ...
...replaced the lamp, I would next chack the ballast. A professional service shop should be able to help with this. It is extremely rare for a lamp to be delivered defective. Hope this helps a bit. ...
...Lamp Ballast has gone bad. This is the power source for the Lamp, and although they usually die completely when they do go, sometimes they will act just as you have described... they fail into a "low ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions