Questions & Answers for: out of balance sensor

...assembly. Right inner fender access cover. Using a 28 mm socket, remove the crankshaft harmonic balancer retaining bolt. Crankshaft harmonic balancer using tool J 38192 or equivalent. Sensor ...

...in a new kit "fly wheel" now car wont start it sounds like when you put the "fly wheel" or harmonic balancer on you wiped out the crank position sensor. The engine ECM/computer needs the crank ...

harmonic balancer bad car runs real bad harmonic balancer bad car runs real bad sputters? etc. The harmonic balancer controls the triggering of the combined crankshaft/camshaft sensor. This controls ...

I changed the harmonic balancer and now it is terribly out of time. Didn't touch any timing belts, distributor or the like. Any advice? There may be a magnet on the harmonic balancer for the ...

...the electrical connector at the sensor. Using a 28mm socket and pull handle, rotate the harmonic balancer until any window in the interrupter is aligned with the crank sensor. Loosen the pinch

...right inner fender access cover/splash shield. Using a 28mm socket, remove the crankshaft harmonic balancer retaining bolt. Remove the crankshaft balancer, using a puller if necessary. For 1992-99 ...

...the electrical connector at the sensor. Using a 28mm socket and pull handle, rotate the harmonic balancer until any window in the interrupter is aligned with the crank sensor. Loosen the pinch

...Hi, The sensor is located to the right of the crankshaft behind the vibration dampner (harmonic balancer). You will need a balancer puller and a special tool to space the new sensor correctly. ...

...the inner fender well cover. Remove the bolts to the sub frame and lower it. Install a harmonic balancer pulley remover and remove the balancer. remove the crank sensor to the right side of the ...

...for being a justanswer customer Dave *** UPDATED BY TSB #91-T-05 DATE: 9/90 The harmonic balancer on these engines is now press fit onto the crankshaft and requires the use of Tool J-38197 ...