...bad thermistor,bad fusing lamp or a bad connector. Fusing thermistor open Fusing thermistor disconnected Fusing thermistor connector defective Fusing thermistor damaged or warped Fusing temperature ...
Question about Classic Plus 26 Air Conditioner
do the thermistors go bad? How can I tell, the Movincool classic plus 26 Do the thermistors go bad? How can I tell, the book says should read approximately 10k ohms @ 73 deg f. What is out of range? ...
...thermistor turns bad it will not let the water to heat or in some cases will boil the water to extreme temperatures. You?ll need to replace the thermistor to resolve this issue. The thermistor is ...
...bad thermistor. It is the flexable temperature sensor that rests on the hot roll to monitor the temperature. Possible causes:• Thermistor bent, out of position• Fusing lamp disconnected• Circuit ...
...thermistor is bad. Several ways to test. 1: Place the end of the thermistor that is located inside the refrigerator into a glass of slushy water and read the ohms resistance on the plug end which is ...
...thermistor is bad. Several ways to test. 1: Place the end of the thermistor that is located inside the refrigerator into a glass of slushy water and read the ohms resistance on the plug end which is ...
...thermistor is bad and needs to be replaced. 2: Unplug the thermistor from the circuit board. It will be the harness that has only two wires going into a hard plastic plug. Leave it unplugged for 24 ...
...on the terminal block. The compressor and fan turned on and the unit started cooling almost immediately. Do I have a bad thermistor and how can I check it to determine it is bad? How to Test ...
Question about 6BAR Wine Cooler
...bad. The test only sees if the thermistor is open circuit or grounded. These thermistors can send bad information to board. Replace the freezer thermistor and I think that will solve your issue. Good ...
...bad. 2. Thermistor is broken, or out of place 3. Fusing temperature -15% less than the regular input voltage To reset this error try the code: "Clear Mode"+107+"Clear/Stop" hold for 5s. Turn ON and ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions