...IC on a Mitsubishi vs 5043? I'm sure it's going bad from all the information I've gathered. The convergence IC's are black in color with white lettering on them and will start with STK. These IC's ...
...ic bad the letters 0n the ics start with stk replace ic you will have a good shot that will fix it. you do need to be able to solder . be careful. there are 2 ics replace both . mcm electronics for ...
Question about VS-45607 45" Rear Projection Television
...bad in the IC. However its recomended to change both because of the bad Ic having green it can actually weaken the other IC and that one will fail shortly. Good Day, ramoas; If the convergence works ...
Question about VS-60805 60" Rear Projection Television
...bad connections small ring crack are hard to see these ic's work hard that is one reason for their large heat sinks running the set and turning it on and off may have induced fine ring cracks. i ...
bad. These IC's operate at a very high temp, and usually only last 4-5 years. If you remove the back of the set, you will want to look for the BIGGEST heatsink in there, on that heatsink, you will see
Question about VS-50705 50" Rear Projection Television
bad. These IC's operate at a very high temp, and usually only last 4-5 years. If you remove the back of the set, you will want to look for the BIGGEST heatsink in there, on that heatsink, you will see
bad. These IC's operate at a very high temp, and usually only last 4-5 years. If you remove the back of the set, you will want to look for the BIGGEST heatsink in there, on that heatsink, you will see
Question about VS-45607 45" Rear Projection Television
...in the vertical section. Vertical problems will appear as horizontal lines on the TV. In this case you have bad capacitors near ithe vertical IC and must also resolder or replace the vertical
Question about VS-45607 45" Rear Projection Television
...of the vertical IC. Replace the three or four capacitors next to the IC. A bad capacitor will overheat an IC and cause solder grounds to separate. Thanks for asking and show a few hands of
Question about WS-48315 48" Rear Projection HDTV-Ready Television
...bad grounds here as well. The vertical IC can be a culprit, as the pins on here have separated as well. Once again look for bad solder grounds on the flyback. horizontal transformer, ...
Usually answered in minutes!
1,423 Questions
661 Questions
607 Questions
562 Questions
482 Questions