testing how can I test a stack flue sensor on my sta-rite sr400na pool heater,I do have an ohm meter. jump for test if bad check gas pressure
Question about Sta-Rite Max-E-Therm Low NOx Pool and Spa Heater - 333K BTU Heavy Duty / Natural Gas
Heater says that water temperature is at 126 degrees and won't turn on bad temp sensor Change temperatire sensor for heater resistence
...is a dangerous thing to do for a dyi'er. If you don't smell gas when it tries to light, it is probably not getting any. Also, your igniter could be bad. Also, you could have a leak before the
what causes ignition lockout High limit switch is bad or open or pressure switch is bad.
Question about Sta-Rite Max-E-Therm High Effiency - Propane Heater - 333,000 BTU
...Product number appears on label, and then add .pdf to search parameter. Any codes?Many thing can be ...
Question about Sr333na Max E Therm Pool & Spa Heater Dual Electronic Ignition Lo Nox 333,000 Btu Natural Gas
Turns on for approx. 30 seconds makes a loud noise and service heater light comes on then it resets itself and does the same thing possible bad flame sensor also check gas pressure and manual bypass
Question about 333 Btu Natural Gas Heater Maxetherm Sr333na
my sta rite heater has no lights on if power to it check transformer if voltage bad board if no voltage bad transformer
Question about 333 Btu Natural Gas Heater Maxetherm Sr333na
...rite 333 nothing happens and it reads E-06. What does this mean? check gas is on if ignitor lights no gas valve see if voltage to gas valve if ok bad gas valve if no voltage bad board or safety ...
Question about Sr200lp Max E Therm Pool & Spa Heater Dual Electronic Ignition Lo Nox 200,000 Btu Propane Gas
Why does my Pentair master temp reads 225 degrees bad temp sensor or hooked up backwards or bypass stuck open Bad temp sensor
Question about Sr200lp Max E Therm Pool & Spa Heater Dual Electronic Ignition Lo Nox 200,000 Btu Propane Gas
...Switch (AFS) closed while trying to fire, then open, Autom?tico Gas Shutoff (AGS) closed. The combinaci?n gas control valve terminals TH and TR closed. What should I check after this? bad flame ...
Usually answered in minutes!
102 Questions
61 Questions
34 Questions
31 Questions