Questions & Answers for: Kenmore bad day

Question about Freezer 20.3 cu. ft. Frost Free Upright Freezer

1 Answer

freezer temp unit maintains 18 degrees on the lowest setting either stat is bad or charge is low. bypassing stat will achieve desires temp. if not then charge is low. if charge is low then buy new. if

Ad

Question about 40494 / 40495 / 40499 Electric Single Oven

1 Answer

...day after superbowl party when we were usung heavily, the broiler and oven, back and forth. Thanks for any help Have you checked for proper gas flow into the over or broiler? This is a gas valve back ...

Ad

Question about 53642 / 53644 Side by Side Refrigerator

1 Answer

...a fried start or run cap and hopefully not a spendy board like everything runs on these days....bad caps(capacitors) will cause compressor not to start and run but arent needed for fans to kick

Question about 79012 / 79014 / 79019 Gas Kitchen Range

1 Answer

...went bad is there a replacement? the book has it as model #10710 key no 198. Thank you Parts for this model have not been available for a very long time. Too bad it was a nice range in its day. ...

Question about Elite 22.4 cu. ft. Bottom Freezer Refrigerator with Adjusta Cube Ice Maker

1 Answer

...day before yesterday, all food in freezer is defrosted, and fridge is sitting at 55 F. Please keep in mind, I'm attempting to diagnose the problem without being there and with little information. You ...

Question about Elite 22.4 cu. ft. Bottom Freezer Refrigerator with Adjusta Cube Ice Maker

1 Answer

...of ice one day then it might be two days before it makes anymore clean the condencer under frige.is the fan working good in the freezer. the ice maker heater could be bad ice maker gear could be ...

day it does the same again. Bad control board? Would love an easy fix. You have already done the test by unplugging the unit to reset the main board and it still will revert back to 88:88 so the board

Question about 73502 / 73504 / 73509 Bottom Freezer Refrigerator

1 Answer

...bad. #2 drive coupling on motor to agitator is bad, #3 clutch is bad, Check out the switch first. If the lid switch is bad it will not send current to start the motor ( safety precaution ).

...relay went out so i fixed it for about two days . why would it be blowing the overload relay, bad compressor maybe ?? should i try a hard start on compressor ?? is the relay side sensitive? ...

...day. Ana; Possible you do have a bad Live neutral or grounding AC plug on wall. Your new one quit in one day , it is possible when your ac line is sparking or bad connection. The main controller or ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Kenmore Freezer Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

Brad Brown

Level 3 Expert

19187 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Kenmore Freezer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...