Questions & Answers for: Jeep Cherokee bad brakes

...brakes you only add new brake fluid dot 3 or 4 any water or contamination can cause failure+abs light a bad booster/and/or/vacuum line will cause excessive pressure on the pedal but should still stop ...

...brakes began to make a hissing/forced air noise and I lost 99% of my braking power. Please tell me this isnt as bad as I fear. If you are talking about when you push the pedal you hear an air noise ...

...brakes, if they're worn or have grit stuck in them, or it could be bad bearings in the front wheel hub. The wheel hub has a tendency to making a whining noise when driving; usually most easily heard ...

...out, if not, replace it. under the dash at the top of the brake pedal the brake light switch is bad this works the brake ...

...brakes checked, you may have a bad hose or sticking caliper, also if you have drum rear brakes then the rear drums may be out of round, this is if its the rear brakes that are grabbing, if it is then ...

the tail light on one side goes off when the brake is applied the brake light works Bad connection or bad bulb. look at bulbs very closely and make sure both elements in intact. clean any corosion in ...

a button on the end that sometimes gets stuck. It turns your brake lights on and off. Sounds like a bad brake pedal switch or the brake pedal return is weak & not depressing the switch fully

...side kick plate. That is the brake light fuse according to the diagram. It is good. Could this be a bad negative or ground connection? I used my meter and got absolutely no voltage to the brake light ...

...brakes and cylinder prioi to install The abs light being on is signaling that there is a bad electrical part in the abs system, usually a bad abs sensor on one of the wheels. You should have the abs ...

...bad brakes . get the brakes checked first. look for road hazard caused (impact) to the 4 wheel sensors. see those wire cables at the 4 axles? ends? that be ABS they must not be damaged. (impact ...