Questions & Answers for: Chrysler Town & Country bad brakes

...brakes drag after a few miles most notably the left front(smoke and melt caliper). I have replaced the calipers and rotors twice but this still happens. I do not think it is the master cylinder as ...

...brakes a few times and replace cap and go. Is this a master cylinder problem or something else?? This sounds like the master cylinder isnt releasing pressure I would change master cylinder. Other ...

...brakes and bled them. worked for very short time and now the pedal goes to the floor. If the fluid level is staying constant then it sounds like the brake master cylinder or the master cylinder ...

...brakes, if the cable is not in a bad state and rusted. if to bad replace rear cables. if it comes loose then oil the cable good at the rear wheels. this may take care of problem.but you may have to ...

brakes. brake pad feels like it needs bleeding but weve done it, it still hard. Pretty much have replaced everything you need to replace continue with hard brakepad. Bleeding isnt going to help a hard

...brakes is bad, Have it checked out and replaced and your brakes will work great again. As you have replaced the pads already, you need to look a you brake disc. If the disc are too polished due to ...

I just changed out the front brake pads and my pedal is moosh and will not stiffen. I have bled all four wheels and itis still moosh. Are your front brake rotors badly worn/scored? This will cause the

get pedal back. the only place i find air is the front driver wheel. Could be a couple of problems, bad master cylinder (not bench bled properly or bad seal out of the box, I have had a few like that)

brakes was not ativated. I think that these two problems are separate, because the parking brake light is not currently on. first thing is to get the OBD codes checked, But in the past Ive had similar

bad e-brake cable will sometimes not release the wheel or both rear wheels causing the brakes to stay on in the rear, they may not be on all the way but on to cause the rear drums to over heat and get