...bad rotors. all of the boots in the front end are not cracked or broken and the bearings seem fine. 53000 miles Warpped rotors can cause alot of funky noises/ vibrations, while driving...make it feel ...
...the problem sounds like there is air in your system have you had bleed your brakes if that does not work have to get a new booster it could be that you got air in your system of a bad master ...
...switch is ok and front turn singles work as well as hazerds for the front only work and singles bad turn signal switch broken inside switch, need to remove steering wheel, remove clip, unplug ...
...brakes are applied. What can it be ? The clunking you hear could very well be a bad shock or a bushing that goes in the trailing arms that attach the rearend to the car. You can check this by putting ...
up the arm. The brake switch can be adjusted try this first. Also on the tail and brake check for a bad ground wire
...switch staying on? try pulling up on the emergency brake pedal to insure the "e" brake switch is'nt bad before you replace a suspected bad brake light switch on the steering column. if you suspect a ...
...dimmer swicth brakes and singal litghs work no head ligths Sounds like your turn signal switch is bad!! Multi-functioning switch it controls your head lights two? Unless you have a push button
Question about 1985 Chevy
...fine, changed stop light switch also. still have problem. you could have a grounding problem,a bad body or frame ground. By the brake pedal there is a switch, it activates the brake lights when ...
brakes are getting bad you probably have rotors on the back and your back brakes will have the little chirpers i call them they make a noise when your brakes are needing to be changed, hope this helps
...brakes checked. it could also be a bad cv joint gone bad causing the noise only on a turn. if its when turning left then the left cv joint has gone bad. replace the left half shaft. some people say a ...
Usually answered in minutes!
363 Questions
210 Questions
125 Questions