Questions & Answers for: Jeep get back off

off the back drum. With the wheel off, give it good hit between the studs, like you were trying to put it on. Hit one side then the other, the drum will start to rock a bit, then pop off. You may want

Back off adjusting screw the number of turns listed below for your transmission. 4. Hold adjusting screw in place and tighten lock-nut to: 41 N�m (30 ft. lbs.) for the front band 34 N�m

...back to the off position fully and therefor i cannot remove the key from the ignition.it wont even turn back to the acsessories. Turn the key back on and move the shifter through the ranges., try ...

...off, they turn back on. I checked the relays, changed bulbs but I dont really know what relay belongs to what. I dont have a manual so I don't really know what the accronyms mean. probably a ground ...

off then comes back on Yes it has a temperature sensor and through convection of the hot water moving to the top of the cooling system as it cools off, the sensor is seeing the temp rise and turns the

...back off take the backing plate off load a bunch of anti sqeek between the pad and plate then the plate and caliper should solve your problem unless its your coposition off your pads some grades of ...

...off.. does it take a puller? Thanks try backing the brake adjuster of it is located inside the drum but there should be a plug that can be removed on the back side of the drum or backing plate. look ...

...off is one click back) The codes will either flash out on the check engine light in pairs of numbers, 5-5 being the end of the test. Or the codes will display in the digital odometer. write down the ...

cable came off back window...can't see where to put it back on cable came off back window...can't see where to put it back on you need a new window regulator

back off?? I took it to get the key checked and they say it still works. When you say "turns right back off", do you mean only that the engine quits, or do you mean the key itself returns to the "off"