Questions & Answers for: axle and spindle

...spindle from axle, with pry bar pop axle out of trans housing. it is easyer to replace cvc axle than to replace or repair cvc joint. ...

spindle. My axle tube has a bearing toward the end and the matching landing on the axle. The truck I got the pieces was a 90 w-150 but the axle tube did NOT have the same bearing toward the end and no

...axle. Pull spindle away from car to get axle out of spindle. Carefully pry between axle and transmission to disengage axle. Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have ...

axle then turn the spindle and move it just to one side of the axle. You should now have full view of the CV axle. Now get a long pry bar and get back there with the pry bar where the axle connects to

...axle out from spindle tie spindle out of the way, note watch out not to break abs connection wirem, unplug it if needed, next put a small pan under the inside axle area to catch any ****** oil that ...

...spindle from the axle and tie aside out of the way. The axle is held into the trans-axle with a circlip, you will need to get a pry bar behind the inner CV joint and pop the inner spline joint out of ...

...axle from the spindle, tap the axle out of the spindle. Once loose put a pry bar between the transmission and the axle and pry the axle out of the transmission. Might be a little hard to pry out but ...

...Remove the lower ball joint nut, remove the lower ball joint out of the spindle. Push the spindle out and push/pull the axle out of the spindle. Pry/pop the axle out of the transmission. Re

...endeavor remove tire. remove axle locknut in the center of spindle. remove lower ball joint . swing the spindle out of the way and separate the axle from the spindle. pull axle out of ...

...spindle axle on a 2001 dodge ram 1500 2wd? And what is the name of it exactly? The spindle is what holds the front tires on. The axle is what holds the rear tires on. To remove the spindle, you have ...