Questions & Answers for: axle seals

Question about 2001 Town Car

2 Answers

Rear Axle Leak Noticed oil on left rear disk and think it is the rear axle seal leaking. Checked the brake calliper and appears ok. How is the rear axle removed on the Lincoln towncar? Also, any tips ...

Ad

I cant remove a rear axle seal to a 1999 honda passport i have a 1999 honda passport with the rear axle seal leaking. i just dont know how to remove the axle seal thank you Axle bearing and seal are ...

Ad

1994 buick roadmaster, oil leaking out of right rear axle, checked brake fluid is full, could it be differential oil leak @ end of axle?? If what you see leaking is very oily and does not evaporate, ...

Question about 2005 F 350 Super Duty

1 Answer

2005 single axle F-350 right side rear seal started to leak on 2005 single axle F350 the seal is different from dually's can you help? Will I need to pull the axle out just to replace the seal? Yes ...

...axle shaft to do this.Pack the new seal with grease, to keep the seals expansion spring within the seal lips. You will need a driver to install the seal,and a hammer ! Good luck! Check the gear lube ...

Question about 2004 Express

1 Answer

How do you change the rear wheel bearings on a 2004 chevy express 1500 van? Axle Shaft Bearing & SealRemoval & InstallationTo Remove: Raise and safely support the vehicle. Remove the axle ...

Question about 2004 Express

2 Answers

have a 1997 plym voyager 2.4 auto trans with a trans leak where driver side axle bolts to tranny the axle just slides in at that spot there is a seal there you will need to pull axle out and replace ...

...seals that fail are , the bearing is allowing , out of spec. moving in the axle so when doing all that hard work ? we check this first. do you know all cars have this book, called the FSM. and all ...

Question about 2006 Liberty Renegade

1 Answer

1992 f150 front axle to diff. seal replacement procedure and tools needed OK, you must remove the front axle assembly to access the axle flange and then the seal, follow the instructions at the link ...

...a bearing packer. In addition, a clean and well-lit workspace will help make the process easier.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...