no power after a power failure.there was nothing coming on . I have tryed a new power suppy broad and a logic broad , with no success Check the fuser i have scx-4z16f printer all in one. Printer power
Question about SCX-4100 All-In-One Laser Printer
SCX 4100 Major Paper jam at rear port. Removed - won't power on I didn't realize paper was jamming in the back. When I opened it there were a few sheets back there. I had to remove the bottom roller ...
Samsung SCX4100 printer cannot power on. My laser printer stopped working. It does not power on. I checked the surge protector that is plugged in and I tried it in another outlet but it does not work.
Question about SCX 4521F All-In-One Laser Printer
Samsung SCX-4521F Multifunction wont power on 18 month old Samsung SCX-4521F Multifunction printer wont power on at all. I've tried multiple outlets and turning on and off, nothing registers on the ...
Question about SCX 4521F All-In-One Laser Printer
Samsung SCX-4521F Possibly lost its power? When Samsung SCX-4521F Possibly lost its power? When I plug it in, it ''ticks'' I have tried another power outlet, another power cord, but continues to tick ...
Question about SCX-6322DN All-In-One Laser Printer
...power to display "system initializing" and does not go forward Alla accensione samsung scx-6322dn display visualizza "system initializing" e non va avanti Dear Try to re assembly ...
system error recycle power samsung 4828 Welcome to Fixya Perform a power drain first by uplugging the power cord from the wall outlet then press and hold the power button for 10 secs. If same thing ...
Question about SCX 4200 All-In-One Laser Printer
SCX-4200 printer - no power in machine, no display, but power definitely going in. Any ideas please? It is most probably a problem with the power supply inside the unit. If the unit switches on, but ...
Problem on my All-in-one Samsung scx-6322DN power to display "initializing sistem" and does not go forword.What can I do? Replace all electrolytic capacitors on the secondary side of the ...
printer doesnt power up Please follow the steps below to hard reset the printer and let me know the result.1.Remove all the cables from the printer.2.Wait for 10 mins.3.Connect only the power cord and
Usually answered in minutes!
1,017 Questions
482 Questions
305 Questions
287 Questions
235 Questions