Question about FEF366 Electric Kitchen Range
Oven will not power up.. relay does not engage I recently went to bake and found that there is no power to either element in my oven. I baked a few weeks ago without incident. Pressing bake on the ...
bake element blew 2 weeks ago got new part...and still won't heat up Depending on how the element blew, in some cases it will also ruin the Electronic Oven Control (EOC) board. This is your clock ...
condenser fan operation is sporadic the compressor works fine and fan runs well outside. the condenser fan inside won't stay on in any mode. it comes on but then immediately kicks off. this cycle will
turns on and runs but will not heat food Either a Hi Voltage component is not working or the relay on the control is not functioning properly. This repair is dangerous and not for the novice. Eric
cooling but not freezing Clean and inspect the coils around the compressor area. Check for a functioning condenser fan and feel the compressor if it is very hot to the touch the relay is probably ...
Question about GLRS234ZA Side by Side Refrigerator
i have a frigidaire double door refrig. it clicks off and on alot is it supossed to do that i put new relays on it Hello and Welcome to FixYa! The clicking sound that comes from the relay is a normal ...
not working Hi, Please check the : - compressor ( Should function normally). - Relays ( No defective relays) - Controller ( potency module should work normal) Regards
Question about GLRS237ZA Side by Side Refrigerator
GLRS237ZCB3 stopped cooling, replaced start relay after replacing the start relay, the unit functioned properly for about three weeks before the same thing happened again. Could this be the defrost ...
Question about FGX831C Top Load Stacked Washer / Dryer
Top load washer will not fill with water. Doesn't matter what setting. Other functions appear to be working but no water. Water pump or some relay appears to have gone out. Water fill will not begin ...
Question about FGX831C Top Load Stacked Washer / Dryer
automotive ones you can remove the cover of the relay as well. Which makes it easier to test since you can just close the contacts by simply pushing them together.You usually test them in pairs as per
Usually answered in minutes!
353 Questions
213 Questions
158 Questions
123 Questions
110 Questions