Audi a3 clutch problems right dunno if anyone can help.. my car struggles to get into reverse gear crunchs and clutch bites right at the bottom i tried bleeding the slave changing the fluid replacing ...
Audi A3 2.0 tdi sport(2005 "55") Clutch/1st & reverse gear I have just brought my audi and am experiancing some problems with 1st and reverse gear. Sometimes when iam moving the car in first of ...
audi a3 has stopped working. The car has recently had new gearbox fitted. The car has been making a whirring noise. The other day it made a grinding noise the engine stopped would not restart for half
...Audi A3,earlier today my little brother stole my keys went out with my car and he later called me telling me that the car has locked all gears. Right now i have towed the car and its true the gears ...
Question about 2008 A3
audi a3 1.9 tdi 2006 had the full clutch replaced has there was a loud metal on metal chaffing noise , was told it could be the thrust bearing on the clutch , still the problem is there after i have ...
Question about 2008 A3
...Audi A3. Clutch only engages in top third of travel and does not slip. When clutch is fully depressed however it still drags and I cannot engage a gear. Switch off the engine, engage first gear and ...
...clutch problems It sounds funny and the gearbox shifter shakes about. clutch problems ae indicated by slipping ( engine rpms rising but not going ant where), slipping may be a faulty clutch master ...
Question about 2008 A3
Audi a3 with 130000 on the clock and clutch is very high too any help thanks gears slipping out will be indicated by the gear lever jumping into neutral.This can be from incorrect rear engagement from
Question about 2008 A3
...Audi A3 s line 2.0 tdi Revving on Idle ' Audi-Sport.net www.audi-sport.net > ... > A3/S3/Sportback (8P Chassis) Feb 1, 2012 - My Car 58 S3, as of last night decided to start revving whilst on idle, I ...
Question about 2008 A3
...Audi A3 2000model 1.8 non turbo. i just changed my slave master cylinder and i tried to bleed my clutch but it doesn't get up. what could be a problem? the master cylinder slave or cylinder or both ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions