Questions & Answers for: attach siphon attachment

attach the hose at the reservoir; from your description, Haier apparently has a separate location. Check that the point that the hose attaches has an opening (many don't, they expect you to drill it).

...you have tried these without success, you might need to clean out the nipple where the siphon hose attaches. Remove the hose, unscrew the nipple carefully, and treat the check-valve inside (usually

...stand pipe, and if it is already raised enough, get a anti-siphon devise to attach the drain hose to the stand pipe. Let us know if you want any further clarification. Thanks for contacting ...

siphon devise to attach the drain hose to the stand pipe. If the tub doesn?t fill to the proper level, it will not go into the wash cycle hence there will not be any agitation. Let us know if you want

...a specific low pressure nozzle. If they are color coded, it is usually black, If nothing else, look for the one with the biggest opening. and attach it. The siphon will work with it Best regards ...

...cap. 2. The way I did it was I disconnected the fuel line from the fuel pump assembly on the tank, attached my siphon pump hose to the fuel line and pumped it

...pressure washer will only siphon from the soap dispenser when you have the low-pressure nozzle attached and then will only sort of dribble out the suds. Good for sudsing, but no good for

...in the pressure washer I have no model number These units come with a detergent bottle that attaches to the spray wand. The manual describes what detergents to use and the attachment reduces ...

siphon hose down to the tank. Disconnect main fuel line to engine, attach hose and put other end in suitable container, run pump to start siphon action. Or, begin tank removal if that is your plan and

...There are other ways, just be very careful as gas is very flammable and can be dangerous. Check the attached links,instruction and guides, Good luck "I hope this helped you out, if so let me know by ...