code cof32 appears cof32 is telling us that ATDC sensor is reading toner supply incorrectly, now this Toner Density Control sensor sits inside the developer unit of this machine, and toner is feed ...
ATDC: set is 140 but the current is 0% my 2050 mach. prints with dark background. initially it was printing very light but after adding a little ammount of toner to the drum the color became better ...
dark background print in minolta EP2050 mach. print color is dark on the background of paper. ATDC was 140 vs 6.0 when it was printing faint(light) but after adding a small quantity of fresh toner to ...
...listed .Well for the Di 450 _CF033 error Description: C0F33. Solution: Check to make sure that the ATDC value noted after running F8 was entered as the "set" value in the Adjust Mode. If the ATDC ...
...ineo 161, problem is erorr cof32, please give me advice how fix that terrible mistake C0F32: Faulty ATDC Sensor Gently swing the IU in the horizontal direction to even out developer in the Developer ...
Question about bizhub 350 All-In-One Laser Printer
...error code C-2557 on this Biz 350 with the finisher, without the the finisher m/c works fine C-2557 ATDC sensor malfunction.Enter in the service mode press following keys: ...
erreur cof 32 ATDC sensor malfunction.Try to change the ATDC sensor gain adjustment value,increase or decrease.If the error persist you must be change the developer and the perform the F8(developer ...
...dis appear but in a few copies it occures again. what am i going to change with my copier? C2557 ATDC Sensor Failure • The scanning value of the ATDC Sensor is less than 7 % while the IU Motor is ...
cof 32 reset minolta dialta toner C0F32 Faulty ATDC Sensor - The measurement taken by the ATDC Sensor (UN1) at a time 2.0 sec. after the Main Motor (M1) has started turning is less than 5% (greater ...
Question about bizhub 250 All-In-One Laser Printer
WHAT DOES THE LETTERS ATDC MEAN AND HOW CAN I USE IT. Automatic Toner Density Control (ATDC) located under the developing unit. Used to control in adding toner to your developer, Calibrate ATDC ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions