Questions & Answers for: Lexmark assembly

...Printhead Lost Hsync Check for the correct installation of the all the cables to the RIP Board assembly and to the Printhead assembly; J2, J3, and J4 on the RIP Board. Go to ?RIP Board? on page

Print head assembly on my Lexmark Optra S 1855 needs to be replaced. My question is what causes the print head to malfunction in the first place? I guess you're getting an error message which is ...

...to replace the fuser roller as you probably welded the plastic to it. Try this procedure: Fuser Assembly Removal 1. Tilt the printer carefully to the rear so it is resting on the ASF. 2. Remove ...

...display Service tip: The printer has detected a problem with the system card, the operator panel assembly cable (part of the top cover access assembly), or the operator panel assembly if POST does ...

...care of you. Possible causes: · Check/Replace the toner cartridge · Check the charge roll assembly (see Note below) · Check the Toner Darkness, Brightness, and Contrast settings · ...

...of media in the machine during POST (Power-On Self Test). Check for media in the exit of the fuser assembly or redrive assembly. Feed a sheet of paper, and if the same error occurs after clearing

...let it sit. but that doesn't always work. how do i fix this problem? Pass thru sensor and flag assembly: The tray 2 option system board did not detect a piece of paper actuating the pass thru ...

...PC cartridge for installation. Is the PC cartridge installed securely? Check the dual drive motor assembly for operation. Open the rear motor cover and check it. 1. Enter Diagnostics mode. 2.

how to replace mirror motor assembly lexmark t632 or printhead I would suggest you contact a certified Lexmark trained technician to replace the printhead or you may contact Lexmark Technical Support.

...ATC) for proper connection. Is the above component properly connected? Replace the Y developer unit assembly. Go to "Developer unit assembly removal". Replace the connection. 3 Perform a very large ...