Questions & Answers for: asko dryer overheating

asko dryer model t760 that overheated the other day. it did finally trip the overheat protection switch on the back, but it did get hot enough to distort a few plastic pieces and put flat spots in the

...asko t731 dryer seems to be overheating. It shuts off after running about 5 min. Tends to run longer on timed dry. If I dry very small loads it runs fine. Otherwise it shuts off Common problem. You ...

asko 700 dryer was overheating sometimes even on low, now not heating at all.Starts, runs for a couple of minutes and shuts off 1) check and or clean you vent.. 2) check air coming out of the vent... ...

...Asko T701 Dryer The blower was full of lint and I cleaned it out. How do I reset the machine? Had the problem three months ago and the tech came out and showed me how to clean but not reset the ...

...asko dryer reset button won't pop back out. the dryer overheated because a piece of cloth got stuck in the basket. when i came outside to check the laundry the dryer had stopped. all the lights were ...

...Asko T700 dryer which is working fine except tripping after half or less of drying time. I can reset and it dries for a while longer, usually tripping again. I have cleaned out the lint and replaced ...

...dryer i think its overheating thats my guess anyway, it has a reset button on it i guess this cuts in and turns the machine off stops it in case it overheats ect.... it heats but once turned on after ...

...outside when it is running to see if it is blowing properly, the air should be hot and feel somewhat forceful. If it seems weak your dryer may be overheating because the ducts have become

ASKO TL751 error messages ? A list of error messages Asko dryers as model T760 or T780 indicate failure by error message (like "Overflow", "Sensor", "Thermistor", ...) while the model TL751 indicate ...

...Asko T7781c dryer programme panel is dead. The mains switch turns on but nothing else functions. There is no reset button ; the dryer did not reset itself. A new circuit board at $300+ ? On the back ...