Questions & Answers for: arp command Office Equipment & Supplies

...arp command to set IP and mac address, arp -a will display the static address but cannot ping the address. Any ideas? Really need a bit more information, like operating system for a start, but here ...

arp timeout Command Use the arp timeout command to configure the amount of time that an entry remains in the ARP cache. To restore the default value, 14400, use the no form of this command. The syntax

...but I can not ping from my PC to Print Server. I assume that I need to assign the subnet also? If it is then how can I assign a subnet using ARP command? thanks, Telnet worked.. thanks for the ...

...arp command (Windows 95/98/NT/2000) From Windows 95/98 MS-DOS prompt or at Windows NT/2000 command prompt, you can use the arp command to assign the IP address to the network interface card. It is ...

...ARP Command component provides the functionality to add, delete, or display the IP address for Media Access Control (MAC) address translation. To flush/Delete the ARP cache in windows ...

...ARP cache you need to do start, run, and then type in cmd in the command line to get to a command promptOnce there use:netsh interface ip delete arpcacheThis is of course assuming you use Windows XP ...

...run the mac-address update arp command to enable the switch to update ARP entries when the MAC addresses of upstream devices change, which shortens traffic interruption period (within

arp expire-time command to change the aging time. You can also change the number of ARP probes by running the arp detect-times command. The default number of ARP probes is 3. When the aging time of an

...command in the system view to disable a trap of a specified module. For example, to enable the hwethernetarpipconflictevent trap of the Address Resolution Protocol (ARP) module, run the following ...