Questions & Answers for: Honda Civic arm 32

2000 civic 4 door trailing arm I am trying to find out if anyone sells the pin that is in this arm that goes through the arm and bolts to the body of the car? junk yard only not even honda has it

...the inner fender well,then take the 17mm bolt out of the bottom of the strut on the lower control arm this will make it drop down.Then take the 14mm bolt louse that fastens the ball joint to the ...

...arm nuts to 47 ft. lbs. (65 Nm). Torque the castle nut to 32 ft. lbs. (44 Nm); then, only tighten it enough to install a new cotter pin. Tighten the wheel nuts to 80 ft. lbs. (110 Nm). Check and ...

...Honda Civic LX Front Passenger side. Lower ball joint. I had a question i bought a used control arm for a 2001 honda civic compared it to the original and everything was the same except the part ...

howto replace control arm bushing does the control arm need to be removed from the body of the vehicle and does the bushing need to be pressed in? Yes, the control arm needs to removed. And the ...

When you turn on the wipers, they do not move but u can hear the motor running the arm has come off the wiper motor drive just push it back on , the wiper rod have come off the motor assembly. you ...

...on. Sometimes they come on when blinker is used. Sometimes when cruise is used. Since the wiper arm and the turn signal arms are on opposite sides of the steering wheel and the cruise is not on ...

...tire on the right front and bending the entire rear left wheel inward. I replaced to lower control arm in the rear, but now the car has severe torque steer. I tried to have an alignment done and

i need help replacing a right upper control arm on my 98 civic si jack up vehicle ,remove tire/wheel,separate upper ball joint from steering spindle. next open hood, look at the right front strut ...

How do I not bend the valves when putting the rocker arms back on Have oil I. Spark plug wells, will remove crank case and replace o rings don't won't to bend valves when putting rocker arm back on ...