Rocker Arms Need torque specs for hydraulic rocker arms on 1984 Ford F-250 6 cylinder engine. 17-23 Ft/Lbs.
Question about 1997 F250 SuperCab
...32-inch) closed end wrench for 5.8L and 7.3L engines on the tensioner pulley bolt and lift the tensioner arm away from the belt. Remove belt. Release tensioner arm slowly. Do not allow arm to snap ...
'86 F250 wiper arm windshield trim removal I have a 1986 F250. There is a reoccurring problem with leaves getting into the resistor for the heating and air conditioning fan control, smoldering and ...
...How to take off Assembly that holds wiper blade from vehicle There are three ways that wiper arms are held on. I'am not for sure which one you have, so will list all three. But before you
I HAVE A 2001 F250 SUPPER DUTY. HOW DO I REMOVE THE WINDSHIELD WIPPER ARM? ALOHA WIPER ARM HAS SMALL COVER ON IT.YOU HAVE TO USE SMALL SCREW DRIVER TO REMOVE SMALL CAP OFF WIPER ARM IN ORDER TO REMOVE
my wiper motor runs, but the wiper arms do not move The wiper linkage may have come off or broken. I would look up under the cowl to see if everything is intact. there is a little plastic bushing that
hello im trying to change my steering box and im having troubles getting the pitman arm off the steering box shaft need advice You need a tool called a pitman arm puller. Most large parts stores ...
power steering gearbox leaks fluid at the pitman arm. Can the seal be replacedin place? how? The pitman arm seal can be replaced by removing the pitman arm, prying out the old seal and driving in a ...
...wipers on but they don't move. take the plastic grill off the top under the screen and refit the arm ,they have a plastic bush and snow has caused it to come off thats all just clip it back on 10 ...
need to change it out. how do i change it? Disconnect the negative battery cable. Remove both wiper arm and blade assemblies. Remove the cowl grille attaching screws and lift the cowl grille slightly.
Usually answered in minutes!
907 Questions
705 Questions
546 Questions
442 Questions
465 Questions