Questions & Answers for: arm 32 Cars & Trucks

...32-inch) closed end wrench for 5.8L and 7.3L engines on the tensioner pulley bolt and lift the tensioner arm away from the belt. Remove belt. Release tensioner arm slowly. Do not allow arm to snap ...

...in pounds. Hope that helps Valve Rocker Arm Bolt 19 N·m + 30° (14 lb ft+ 30°) A GM dealer shows me another source, which says 32 Nm (24 lb-ft). Not sure which one is right but they screwed up my

...side that you can pull out with a flat screwdriver, plastic cowl covering the motor has a couple screws 9/32 1/4 , unbolt the arm one nut and four bolts on the motor not too bad should be done in ...

...arm nuts to 47 ft. lbs. (65 Nm). Torque the castle nut to 32 ft. lbs. (44 Nm); then, only tighten it enough to install a new cotter pin. Tighten the wheel nuts to 80 ft. lbs. (110 Nm). Check and ...

...bolts .then remove suspension arm bracket nut .remove suspension arm bracket bolts. remove rear bracket and suspension arm. torque ball stud nut 44 ft lbs torque suspension arm rear bolts 32 ft

...Lower intake Stage 1: Tighten to 15 Nm (11 lb-ft). Stage 2: Tighten to 32 Nm (24 lb-ft). Rocker Arms Stage 1: Tighten to 10 Nm (89 lb-in). Stage 2: Tighten to 32 Nm (24

...arm shaft retainer bolts to 23 ft. lbs. (32 Nm). * Check valve adjustment and install the valve cover. Tighten the valve cover bolts to 16 inch lbs. (1.8 Nm) for the 1.5L engine or to 29 inch lbs. ...

...taurse 3.0 ohv rocker arm torque specs To install, reverse the removal procedure. Tighten the rocker arm bolts in two stages. Stage 1: Tighten to 10 Nm (89 lb-in).Stage 2: Tighten to 32 Nm (24

32 Nm).Rocker arm cover using a new gasket. Torque the rocker cover bolts to 89 inch lbs. (10 Nm).PCV valve and hoseHeater bypass pipe. Torque the screw at the water pump to 106 inch lbs. (12 Nm), the

Arm Bumper .................... 32 Nm (23 lb ft)
Lower Control Arm to Frame Nuts and Bolts .................... 165 Nm (121 lb ft)
Shock Absorber to Control Arm Bolts .................... 27 Nm