Questions & Answers for: Plymouth arm 32

Wiper arm problem. Can't get the wiper arm assembly off motor post need help please? have you removed the cover and nut from the spindle. If so, lift the blade up from the screen until it locks facing

how do I remove & install wiper arms on a 1994 I can not find a nut or bolt on the wiper arm. I have tried to pull them off by hand,pliers and pry bar while pulling a clip on the side of the arm ...

Need to remove the rear window wiper arm assembly. How is this done? Any suggestions? flip up plastic cover at base of arm to expose a 13mm nut,remove nut then arm

replacing windshield wiper motor Remove the wiper arms. Take out the screws that hold down the wind shield cowl. Unplug the wiper motor (center driver's side) by pulling out the red clip on it and ...

...windsield wiper does not work on. What is most likely the problem? Driver side works. if the wiper arm is held on by a nut, try tightening it. you should be able to pry the appearence cap off with a ...

engine code 32 on 1998 plymouth 3.0 engine Here are the common engine error codes for plymouth. 32 (1984 only) power loss/limited lamp or circuit 32 EGR gases not working (1988) - check vacuum, valve ...

...it. there is no fluid leeks. How do I repair this or fix ? Under neight the dash if you follow the arm of the clutch up there shoud be a coil spring conected to the clutch if it came disconected the ...

what is the rocker arm torque on a 1994 plymouth voyager se 3.3l Its not realy measured by torque on the rocker arm it self because the arm is perloaded by the valve spring plus its a lock nut .The ...

can not get the back window closed. unable to figure out how to work the latch to close it. the arm that holds the window open has a pivot in the middle of the arm.if you push in this area of the arm ...

...32-35psi, try 28. Note this is not a fix, just a band-aide to get you by untill you fix the problem. These old Chryslers are great cars, but they do have front end issues. The front ...