Questions & Answers for: Briggs & Stratton arm 32

Question about Briggs Stratton Vanguard V - Twin Vertical Ohv Engine with Electric Start 23 Hp, 1" X 3 5/32" Shaft, ModelNo. 386777 - 0036 - E1

1 Answer

Trying to find starter for 12.5 vangard v twin

trying to find starter for 12.5 vangard v twin motor. my model number is 9108304 on starter but can't find anything the same. anytime you deal with small engine parts you MUST be armed with the engine

Question about Briggs Stratton Intek V - Twin Vertical Ohv Engine with Electric Start 22 Hp, 1" X 3 5/32" Shaft, ModelNo. 44K777 - 0027 - E1

1 Answer

20 hp b&s runs wide open

...sounds like the gov. fell out in to the oil pan. if you remove the gov. springs and let the gov. arm move up. it will fall out. no book will till you that. if that happend you will have remove the ...

Question about Briggs Stratton Intek V - Twin Vertical Ohv Engine with Electric Start 22 Hp, 1" X 3 5/32" Shaft, ModelNo. 44K777 - 0027 - E1

1 Answer

How do you adjust the valves on the v twin model

...when you fill air coming out of the head. make the piston come all the way to top. watch rocker arms so that they the same hieght. use a filler gauge ( .005 ) put betwen the rocker arm and the ...

Question about Briggs Stratton Intek V - Twin Vertical Ohv Engine with Electric Start 22 Hp, 1" X 3 5/32" Shaft, ModelNo. 44K777 - 0027 - E1

1 Answer

Briggs and Stratton Intek V

Briggs and Stratton Intek V twin 22HP motor misfires. Misfiring could be caused by simple things like fouled or worn out sparkplugs or an ignition system that is slightly faulty or Fuel problems such ...

Question about Briggs Stratton Intek V - Twin Vertical Ohv Engine with Electric Start 22 Hp, 1" X 3 5/32" Shaft, ModelNo. 44K777 - 0027 - E1

1 Answer

Popping thru carb, checked timing its ok,the push

popping thru carb, checked timing its ok,the push rods on three rocker arm hardley move one opens good, problem started all of a sudden. INtake valve adjustment needed. at least on one cylinder. maybe

Question about Briggs Stratton Vanguard V - Twin Vertical Ohv Engine with Electric Start 23 Hp, 1" X 3 5/32" Shaft, ModelNo. 386777 - 0036 - E1

1 Answer

No compression when the rocker

no compression when the rocker arms are on Work through it step by step options are valves not seating valve guide dropped and holding the valve open broken or weak valve spring piston holed rings ...

Question about Briggs Stratton Intek V - Twin Vertical Ohv Engine with Electric Start 22 Hp, 1" X 3 5/32" Shaft, ModelNo. 44K777 - 0027 - E1

1 Answer

I need the linkage diagram for a 20 hp briggs and

...hooks up to the throttle shaft closest to the engine. the governor spring attaches the governor arm to the throttle linkage. The choke cable attaches to the shaft farthest from the engine. I hope ...

Question about Briggs Stratton Intek V - Twin Vertical Ohv Engine with Electric Start 22 Hp, 1" X 3 5/32" Shaft, ModelNo. 44K777 - 0027 - E1

1 Answer

Governor does not seem to work

...you try to adjust the governor by putting the throttle full and unloosen the screw on the governor arm and push the governor piece the same direction as the throttle opens and tighten the

Question about Briggs Stratton Intek V - Twin Vertical Ohv Engine with Electric Start 22 Hp, 1" X 3 5/32" Shaft, ModelNo. 44K777 - 0027 - E1

1 Answer

Briggs straten vale adj

...you use a business card for the gap get the valves all the way up loosen the nut on the rocker arm snugg rocker arm bolt til you have slight resistance pulling the card out tighten nut while ...

Question about Briggs Stratton Intek V - Twin Vertical Ohv Engine with Electric Start 22 Hp, 1" X 3 5/32" Shaft, ModelNo. 44K777 - 0027 - E1

1 Answer

18.5 hp Briggs & Stratton putting in rocker arms back, one goes in to far?

18.5 hp Briggs & Stratton putting in rocker arms back, one goes in to far? I replaced the head gasket, for white smoke. Now when putting back the rocker arms the steel rod seems to go in the hole ...