Questions & Answers for: GMC Sierra 1500 app sensor

Question about 2000 New Sierra 1500

2 Answers

code P0157 and P0137 codes P0157 and P0137 what are they ??? I know tha P is power train . Hi P0157 is 02 sensor circuit low voltage bank 2 sensor 1 P0137 02 sensor circuit low voltage bank 1 sensor 2

Ad

...is jammed full of **** or debris it wont get a good signal. Here is a copy of a GM bulletin that applies to you concerns of low speed ABS activation. Antilock Brake (ABS) Activation At Low Speeds ...

Ad

Question about 2003 Sierra 1500

1 Answer

...sensor display varies with the altitude. With the ignition ON and the engine OFF, 103 kPa is the approximate value near sea level. This value will decrease by approximately 3 kPa for every 305 ...

Question about 2003 Sierra 1500

1 Answer

pressure sensor fitting, if necessary. To Install: NOTE: If the fitting has been removed, clean and apply sealant to the threads before installing it. Install the fitting until snug, if it was removed

...is showing bank 1 sensor 1 heated oxygen does that mean the sensor is bad or is something else is happening to make that o2 sensor not operate correctly? does the problem code say its a lean ...

Question about 2008 Sierra 1500 2WD

1 Answer

...APP sensor 1 and 2 signal voltages at rest position are near the low voltage reference and increase as pedal is actuated. Before a APP si condemd try this GM has a mass air cleaner try cleaning it ...

Question about 2008 Sierra 1500 2WD

1 Answer

location of knox sensor HI, they are located under intake manifold. The first sensor is located in the front of the engine and the second sensor is located in the back of the engine. Remember to ...

why is my abs light on after replacing my speed sensor? What speed sensor did you replace? Was the light on before you replay the sensor? Why did you replace the sensor? Did you check to see if the ...

i need to know where is bank one sensore 2 fixed i found 4 sensors in cross of exhaust pipe and i don't know witch one sensor 2 in bank one Bank one sensor two is located on the driver side after the ...

What else could cause a rough idle when cold besides the maf sensor if the sensor is unplugged the truck runs fine.Have replaced the sensor already and tried cleaning the old one also ? Temp sensor in

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...