Questions & Answers for: Cadillac app sensor

APP (Throttle Position) Sensor 2 Circuit Performance B3832 - Window Position Sensor Circuit B1004 - Keep Alive Memory (KAM B0162 - Ambient Air Temperature Sensor Circuit the translation isnt very good

...APP) System Performance. Your car uses "fly by wire" meaning that when you press the gas pedal, there isn't a cable but rather a sensor that detects how far your pressing the pedal. that ...

...sensor (APP) /switch D --high input===causes -- wiring short to positive--APP sensor/switch Also --throttle position sensor/ switch (TP) D high input===causes wiring short to positive ---TP sensor ...

...pipe hooks to throttle body , should be a three wire plug connected to it , held on with 6mm torx screws Called Accelerator Pedal Position Sensor (APP) Located At Top Of Accelerator Pedal

Where is the throttle position sensor located on a Cadillac Escalade 2007 TPS is the throttle control module. Entire throttle body. Needs to go on a scanner. Make sure it is the TAC or APP sensor.

APP) Sensor 1-2 Correlation Print this code data Trouble Code Conditions: The battery voltage is more than 7.0 volts. The ignition is ON or the engine is operating. DTC P2138 run continuously once the

APP) Sensor The APP sensor is mounted on the accelerator pedal assembly. The APP is actually 2 individual APP sensors within 1 housing. These are 2 separate signal, low reference, and 5-volt reference

...APP) sensor 1 - The APP sensor 2 • The throttle body assembly includes the following components: - The throttle position (TP) sensor 1 - The TP sensor 2 - The throttle actuator motor - The throttle ...

I need to know where is the location of the crankshaft position sensor for a 2009 Cadillac SRX, V6, engine 3.6L. Here, it is number 8 https://photos.app.goo.gl/dLjimxP54MrbtFdK9

APP) Sensor 1-2 Correlation P2138 • The ECM detects that the voltage difference between APP sensor 1 and 2 is greater than 0.23 volt, 0.25 volt for LLT, with the pedal released. • The ECM detects that