Questions & Answers for: Aprilia how to take apart a bike

...apart you need to disconnect the cable from the lever and then you will have to take the clutch cover off. before you do this you will need to lean the bike on its side as you will lose the gearbox ...

...bike is completely apart. getting the bike to a rollin chassis isn't the problem i am having. its how the harness/wiring throttle bodies and pretty much all the electric run on this bike. can anyone ...

...apart and there in not any flange just the caliper that fits flush against the mount and can and did twist and bind. I am sad because I like the owner and the dealer and am surprised they are trying ...

...bike was ok untill i took front wheel out and since i put it back in the brake disc is now scraping on rivots on the brake pads Hi ...... I dont have experience of this particular model but something ...

...bike wasnt finding gears apart from 1st n 2nd but have been told that it is the gear lever not returning to position after each gear change that is causing the problem.I have only been riding a few ...

...apart from that the scooter runs fine. This could well be lack of oil in the gearbox or possibly a stretched belt which rubs on something when not under load Good Luck Hope this helps. (If it does ...

apart and checked cable running to connector plug,seemed fine.unplugged connector blocks around front end,cleaned them up,sprayed wd40 down,dried them,still no luck.it must be a dodgy wire somewhere,i

apart get loads of wd 40 take the cylinders out all 4 of them with plyers or mould grips gently twisting and turning whilst using wd 40 once out clean the holes good and the cylinders all 4 of them on

...bike Without pulling the motor apart there is no way of telling, maybe the bearing caps were not tightened, possibly the ring gap was wrong and it seized in the bore and broke the rod, there are lots ...

...apart recently? Has the ignition timing been altered? Have you checked for compression? Have you got the correct fuel in the tank? (If the bike has been standing for some time, drain the fuel and put ...