...rem connection or is the amp just bad.oh and the amp was pretty hot when i touched it cause i thought that it could have been over heated but its cooled down and has not gotten any better. Check the ...
REM cable as well as power cable from capacitor. run a fused + wire from your battery to the + of the cap ground the - of the cap to a good grounding place on your car run a wire from the + of the cap
...wiring diagram for amp can i get a wiring diagram for kac-7203 + red power to battery - black negative cable to body/ground rem blue remote wire that connects to blue wire on the back of your cd ...
...amp rem cabel then the resistor burns down The power cable and the rem cable need to have different power sources. The best thing to hook the rem. to is a power antenna wire, or if you don't have a ...
...amp to the rem pin 4 - then pass 2 rca cable from the radio to the back of your car the radio side plug it to the sub or rear output rca cable and the same thing for the power amp 5 - you sub wouffer ...
...to your amplifier B+ and a thin wire from the jvc sterei to the amp for the remote REM and an RCA cable for the sound system the negartive wire keep it short as you can and connect it to the ...
Question about Scosche High Performance Amplifier Car Audio Amplifier
another car before and it all worked but after a year and a reinstallation it does not work. :S Be sure you have 12 volts on the remote wire. Fuse power for amp is switched using the REM (remote) wire
Question about Scosche High Performance Amplifier Car Audio Amplifier
rem on the amp 3 rca cabel should be pluged in the channels are using cause you tell me that the amp is 4 channel from the model numbers 4 clean and scrape off paint on the metal surface you are going
amp is on even when the car is turned off i removed the REM cable, it is still turned on make sure the power wire isnt touching even a little bit....had the same problem with an explod amp and one ...
Question about XTA880.2 Car Audio Amplifier
...amp or do I nee to get special ends Bare and tin the ends of your power and ground cables, they can be up to 4agw. The REM is for the remote power on function to come from your key switch and can be ...
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions