overheat during winter if I turn my stereo up. Does this sound like it is only overheating, or is there another problem? Should I mount the amp somewhere else? You could just have a simple idling bias
...amp would most likely overheat and go into protection. I'd wire them the way you have them wired. Each channel of the amp outputs only 100 watts into 4 ohms. That is adequate for regular full-range ...
amp would overheat and fail. One 4 ohm sub would be OK, and it would receive the full 500 watts as stated in the specifications. You could connect four 4 ohm subs, two each in parallel to each channel
...amp inside a box with no airflow for cooling, it will overheat and cut out no matter how you connect it, or what the impedance load you are running. Higher impedance equals less power, less heat. ...
...amp overheat i've had this rockford fosgate amp p5002 hooked up about two weeks and it would work for about 5 minutes then cut off and go into thermal mode. then the other day i turned on my car and ...
Question about Punch P5002 Car Audio Amplifier
...might have also bridged your amp with your speaker wires which would cause your system to run on a different ohm which would cause the bass to get louder then overheat you amp which would turn it
Question about Punch 500a2 Car Audio Amplifier
...yes, if you add a 1 ohm resistor to the negative terminal of speaker. TO DEVELOP FULL POWER, THE AMPLIFIER REQUIRES EITHER 2 OHMS PER CHANNEL WHEN UNBRIDGED OR YOU CAN BRIDGE IT, BUT THE TOTAL
Usually answered in minutes!
87 Questions
58 Questions
47 Questions
26 Questions
21 Questions