Questions & Answers for: MTX amp overheat

...of 4 ohm speakers in parallel to the amp bridged because the amp will see the parralleled load as a 2 ohm load and will overheat and shut itself down.Try checking that stuff out and good luck to ...

amp will not overheat. But the output will be significantly reduced. It would be best to use a "Y" adapter with a single female and two male connectors to split the channel into both inputs. Hope this

...overheat your amp and send it into protection mode, both of which are what you're seeing. You never want to have two D4 subs with an amp that only handles 2 ohms, because you can't get a 2 ohm load ...

...is too low it will cause this same thermal over heat. If you have 2ohms in sub and a 4 ohms stable amp, you will overheat. Check the ohms rating of the sub to make sure this is not the ...

...wiring if you haven't.  If your running this at 1ohm.  You need a second battery, or a H/O alternator.  This amp draws some current and if you can't feed it, it will

...of heavy play my amp will overheat. cools down then automatically comes back on. It is being driven so hard there is danger of burning out the output stages so it goes into protective