Amp keep blowing the 20amp fuse As soon as you put power to the amp it blows the fuse. This happens even if no speakers are connected. Any idea? There seems to be a short circuit inside your amplifier
...amp location and do the same just tie that into your left channel and tape or get a rubber cap to put over the other one i wish i could draw you a diagram of it hard to explain when typing it if you ...
Question about MRP-M350 Car Audio Amplifier
...location, like the trunk. Either way, the wiring connections required will be the same. To install: 1. Mounting the equalizer: A remote-mount EQ can be securely mounted with just a few screws. ...
Question about MRD-M605 - V12 MONO AMP 600WX1 RMS 2 OHM Car Audio Amplifier
...whatup_132, If the M605 fails and displays "CUR", it means that there is excessive current to the amp. The most common causes for excessive current draw is operating the amp into a lower impedance ...
Question about MRD-M605 - V12 MONO AMP 600WX1 RMS 2 OHM Car Audio Amplifier
Just hooked up the cde 100 and can't get my amp to power up just hooked up the alpine cde 100 and can't seem to get the amp to power up any more. Checked everything. Thinking the rca hook up in the ...
I'm using alpine PDX5. using 5diffrernt input and getting 5 outputs after some times amp cut off and red light on in the amp.is any idea why is happning? Check your ground wire first, #1 issue i've ...
...strip the power cable, cut it, and insert the fuse in the specified location. 10. Connect the power wire to the amp first, and then to the battery. 11. Power up your system, and play some
location. Check the live power wire as well, it should be connected directly to the battery. Then check the speaker leads to the amp. They should not be in contact with the vehicle chassis, or (at the
Question about MRV-F407 Car Audio Amplifier
...location. Also make sure the speaker leads aren't touching each other at the input on the amp. Then make sure your live power wire has a good connection to the battery and the amp. Finally, check the ...
...amp; then Radio antenna. But before all checks pl chk sound with your CD player. If it works then no need to check above. then tune your radio at different frequency and at different location as the ...
Usually answered in minutes!
114 Questions
80 Questions
69 Questions
73 Questions
63 Questions